HyperX HX318LC11FBK2/8 Low Voltage Memory Kit

The type of buffering applied to a memory module, indicating whether the RAM is unbuffered (unregistered), buffered (registered), or fully buffered. This attribute helps users understand compatibility and performance characteristics for computer systems.

The number of clock cycles that a memory module takes to complete a read operation after the address has been sent. It indicates how quickly data can be accessed from RAM and affects overall system performance, especially in high‑speed memory configurations.

Specifies the type of device or system that the product is intended to be used with, such as a PC, server, notebook, surveillance system, or other electronic equipment. The value represents a single category and can be used to filter or group products by their target platform.

Indicates whether the memory module or component supports Error‑Correcting Code (ECC) for detecting and correcting single-bit errors during operation. A value of "Yes" means ECC is enabled, allowing automatic correction of data corruption; a value of "No" indicates no ECC support.

The vertical dimension of a product measured from its lowest to highest point. It is expressed in a physical unit such as millimetres, centimetres or inches and applies to any item where height is relevant, including books, electronics, furniture and other objects.

The total amount of internal memory available in a device, expressed as a data size such as megabytes (MB) or gigabytes (GB). It indicates how much information the component can hold for active processes and affects multitasking performance.

The type of memory physically installed inside a device, such as DDR4 SDRAM, LPDDR3, or other RAM variants. It indicates the architecture and generation of the internal memory modules that the product uses or supports.

List of Linux operating systems that the product can run or support, including specific versions and architectures when relevant. Each value represents a distinct Linux distribution or kernel version supported by the hardware or software.

The maximum operating frequency of a memory module, expressed in hertz (Hz). It indicates how many cycles per second the RAM can perform and is typically reported as MHz or GHz. This value helps users compare performance potential across different memory types and system configurations.

The physical configuration or size classification of a memory module, such as SO‑DIMM, UDIMM, RDIMM, or on‑board. It indicates the form factor that determines compatibility with motherboards and other hardware components.

The total number of individual memory sticks that make up a memory kit or are installed in a device, expressed as an integer count.

The classification of a device’s memory technology, such as DDR4 SDRAM, GDDR6, or MLC NAND. It indicates the underlying architecture and generation that determines performance characteristics like bandwidth, latency, and power consumption.

Specifies the capacity of each memory module in megabytes (MB) and its data bus width in bits. The value is expressed as a pair separated by an "x", for example "1024M x 64" indicates a 1 GB module with a 64‑bit wide interface.

The form of packaging used for a product, such as box, blister pack, bag, or pallet. It indicates how the item is contained and protected during shipping and storage.

The time required for a memory controller to activate a row of cells before data can be accessed, expressed in nanoseconds (ns). It indicates the latency between issuing a read/write command and when the data is available, which affects overall memory performance.

The horizontal measurement of a product, expressed in a linear unit such as millimetres or inches. It indicates how wide the item is from one side to the other and is used for sizing, fitting, and compatibility purposes.

A list of Microsoft Windows operating system versions that the product is compatible with, including any relevant architecture or edition information.